KinkyCrafter 20080620 – Craft segment – Flogger Stand

Tonight I cover the construction of my new Flogger Stand. It’s made out of about $3 in small metal hooks, $2 in PVC fittings, and $5 in PVC pipe. The end product ended up being sturdy enough to hold a dozen floggers, breaks down into 3 pieces that fit in my larger toy bag, and only costing $10. The PVC pieces were cut to length to minimize the packed size while keeping the flogger tails off the floor. I made sure the base was wide enough to keep it from tipping easily. It’s very important to glue the two lateral pieces into the two T’s that they go in so that the main upright piece doesn’t pivot. I used superglue, which is functional but not the best choice. The small metal hooks screw in, but drilling a very small starter hole makes this much easier. The hooks can also be bent open a bit more to make it easier to get things on and off of them.

Finished product in action:

Feel free to contact me with any questions that you have at

Component pieces:

3 main pieces disassembled:

Assembled final stand:

Any questions?

1 Comment »

  1. Sabrina Said,

    August 26, 2008 @ 12:40 pm

    Very nice! Going to have to bookmark this page and make a note to grab this stuff on next trip to Dom Depot! 🙂

RSS feed for comments on this post · TrackBack URI

Leave a Comment